The performance of the laser marking machine is stable and unstable, which is a factor that everyone will consider when choosing a laser marking machine. The performance stability of the laser marking machine is very important and affects the continuity of industrial production. Even a high-quality vision laser cutting machine will be unstable, and the marking efficiency of the equipment at this time will be greatly reduced during operation, which is very unfavorable for manufacturing and production activities. So, how do you think the performance of the laser marking machine is stable and unstable? The following editor summarizes these points for everyone.

11.png 

The performance stability of the vision laser cutting machine is affected by various factors. Generally speaking, the more expensive laser marking machine is more secure in terms of performance stability. The performance stability of the laser marking machine can be seen from these four factors:

1. The level of craftsmanship. The level of craftsmanship has an impact on all aspects of the laser marking machine, especially the installation of beam expanders, galvanometers, and marking needles. If the installation position is not adjusted properly, it will lead to deviations in the marking position and affect the laser spot.

2. environment. The ambient temperature has an important influence on the operation of the laser marking machine. If the ambient temperature is too high or too low, the cooling capacity may be unstable. At this time, the marking effect will be unstable, and the laser marking machine needs to be externally processed. Cool down or keep warm.

3. The focal length is not accurate. The focal length of the laser marking machine will also cause the performance of the laser marking machine to be unstable. At this time, it is necessary to adjust the focal length.

4. The lens has abrasion and dirt. The laser beam of the laser marking machine engraves and marks on the material through the lens. Once the lens is worn and dusted, the laser beam is prone to offset, resulting in poor marking results. At this time, it is necessary to clean the lens. After the lens is cleaned, the effect is still not achieved, and the lens must be replaced.

 

WHAT ARE YOU WAITING FOR? CALL US NOW!

图片2.png