Why should the laser machine be maintained and maintained? In the daily use of the laser cutting machine, for safety protection and efficient production, it is often necessary to pay attention to whether there are problems such as abnormal light emission, water tank alarm, net belt deviation, machine stuck/abnormal noise, etc., in order to avoid the above machine failure events , The daily maintenance of the machine and...

Why should the laser machine be maintained and maintained?

In the daily use of the laser cutting machine, for safety protection and efficient production, it is often necessary to pay attention to whether there are problems such as abnormal light emission, water tank alarm, net belt deviation, machine stuck/abnormal noise, etc., in order to avoid the above machine failure events , The daily maintenance and maintenance of the machine is very important.


Air conditioning water tank maintenance

1. Recommendation: Clean the water tank and replace the circulating water once a week.

2. Note: Make sure that the laser tube is filled with circulating water before the machine works.

The water quality and temperature of the circulating water directly affect the service life of the laser tube. It is recommended to use pure water.

High temperature in summer, if the water tank temperature exceeds 35 ℃, you need to replace the circulating water, or add ice to the water to reduce the water temperature.

3. Clean the water tank: first turn off the power, unplug the water inlet hose, let the water in the laser tube flow into the water tank automatically, open the water tank, remove the water pump, and remove the dirt on the water pump. Clean the water tank, replace the circulating water, restore the water pump to the water tank, insert the water pipe connected to the water pump into the water inlet, and arrange the joints. Turn on the pump separately and run it for 2-3 minutes (fill the laser tube with circulating water).


Fan/lens/rail beam

Fan cleaning:

When it is found that the fan has problems such as insufficient suction and poor smoke exhaust, first turn off the power, remove the air inlet pipe and the air outlet pipe on the fan, remove the dust inside, and then turn the fan upside down and turn the fan blades inside Until it is clean, then reset the fan installation.


The rail beam is recommended to be cleaned once every half a month:

Use a dry cotton cloth to wipe the place where the rails on both sides contact the roller until it is bright and dust-free. Change to a clean cotton cloth dipped in a little lubricating oil (sewing machine oil can be used, do not use machine oil), and slowly push the laser head about a few times. The lubricant can be evenly distributed.


The lenses should be cleaned every day:

1. The lens should be wiped gently, not to damage the surface coating;

2. The wiping process should be handled gently to prevent falling;

3. Be sure to keep the concave face down when installing the focusing lens.